Use this Procedure for Vehicles
with
Driver Information Center Buttons
This information is in your Owners Manual in the
Drivers Information Center Section.
1. Insert Key and turn to ON position so you can access Driver
Information Center
2. Press the vehicle information
button until
PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first keyless remote at
the same
time for approximatley 15 seconds. A chime will sound indicating that the remote
is
programmed.
5.
To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove
key.
Test
remote(s).
Use this Procedure for Vehicles without
Drivers
Information Center Buttons
To access this display, the vehicle must be in Park
(P) with key in the on
position (as far
as
you can go without cranking engine)
1. Press the trip odometer reset stem until RELEARN REMOTE
KEY displays.
2. Press and hold the trip odometer reset stem for three seconds.
The message REMOTE
KEY LEARNING ACTIVE will display
3. Press
and hold the lock and unlock buttons on the first keyless remote at the same
time for approximately 15 seconds. A chime will sound indicating that the remote is
programmed.
4. To
program additional remotes at this time repeat step 3.
This vehicle
can have a maximum of eight remotes programmed.
5.
To exit programming mode turn key off and remove key.
Test
remote(s).