Use this Procedure for Vehicles with
Driver
Information Center Buttons
1. Insert Key and turn to ON position
so you can access Driver Information Center
2. Press the vehicle information button until
PRESS TO RELEARN REMOTE KEY displays
3. Press the set/reset button until
REMOTE KEY LEARNING ACTIVE displays
4. Press and hold the lock and unlock buttons on the first keyless remote at the same
time for approximatley 15 seconds. A chime will sound indicating that the remote is
programmed.
5. To program additional remotes at this time repeat step 3.
This vehicle can have a maximum of eight remotes programmed.
6. To exit programming mode turn key off and remove
key.
Test
remote(s).
Use this Procedure for Vehicles without
Drivers Information
Center Buttons
To access this display, the vehicle must be in Park
(P) with key in the on
position (as far as you can
go without cranking engine)
1. Press the trip odometer reset stem until RELEARN
REMOTE KEY displays.
2. Press
and hold the trip odometer reset stem for three seconds.
The
message REMOTE KEY LEARNING ACTIVE will display
3. Press
and hold the lock and unlock buttons on the first keyless remote at the same
time for approximately 15 seconds. A chime will sound
indicating that the remote is
programmed.
4. To
program additional remotes at this time repeat step 3. This vehicle can have a maximum of
eight remotes programmed.
5.
To exit programming mode turn key off and remove key.
Test
remote(s).