IMPORTANT: Before entering programming mode, have in
possession all of the remotes you will be using on the vehicle. Once you program the remotes , all previous codes will
be erased from the memory.
1. Close
the vehicle doors.
2. Insert
key in ignition and turn to ON (As far as you can without cranking engine)
3. Turn
ignition OFF and remove the key from the ignition.
4. Press
and hold the driver side door lock switch in the UNLOCK position.
5. Insert
the ignition key into the ignition and remove. (Do not turn the key.)
6. Insert the ignition key into the ignition and remove. (Do not turn the key )
7. Insert the ignition key into the ignition . (Do not turn key.) Leave the key in the lock.
8. Release
the door lock switch. The vehicle will sound three beeps in order to verify the Program Mode has been activated.
9. Press
the LOCK and UNLOCK buttons together on the keyless remote and hold until the vehicle beeps twice to verify that
the transmitter has been successfully programmed (this may take approximately 15 seconds).
10. Perform
the previous step to program up to four transmitters (including your old ones).
11. Remove the ignition key in order to exit the Program Mode.