|
|
1.
Insert key in ignition and leave in the OFF position 2. Locate the Data Link Port.
It is located under dash drivers side. Be sure you know which pins are 8 and 4.
3. Make sure there are metal
contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper
wire (leave the jumper wire connected throughout the programming procedure).
Make sure you know which terminals are 8 and 4.
4.
Close doors.
5. Turn ignition to the ON position (as far as you can go without cranking the engine). Doors
will lock.
6. Press
and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 15 seconds, the vehicle will respond by locking and
unlocking the doors. Release the
buttons on the transmitter.
7. Within one minute, repeat the previous step on the remaining transmitters to be
programmed.
8. Remove jumper wire applied to th OBDII Port.
|
|
|
|
|
|
|
|
|
|
|
Sorry we are not responsible for any damage done to your car by following or trying to follow these
instructions, i have never heard of anything like that happening but nevertheless we are not responsible for any of your actions.
We are not responsible for any mistypes or wrong info, we strive to have the most current info and
services possible
|
|
|
|