IMPORTANT: Before entering programming mode, have in
possession all of the remotes you will be using on the vehicle. Once you program the remotes , all previous codes will
be erased from the memory. The other remotes will not be functional until you program the remotes again.
1. Close the vehicle
doors.
2. Insert key in ignition
and turn to ON (As far as you can without cranking engine)
3. Turn ignition OFF and remove the key from the ignition.
4. Press and hold the
driver side door lock switch in the UNLOCK position.
5. Insert the ignition
key into the ignition lock cylinder and remove the key.
| (Do not turn the ignition key in
the lock cylinder.)
6. Insert
the ignition key into the ignition lock cylinder and remove the key.
(Do not turn the ignition
key in the lock cylinder.)
7. Insert
the ignition key into the ignition lock cylinder. (Do not turn the
ignition key in the lock
cylinder.) Leave the ignition key in the ignition lock
cylinder.
8. Release the door
lock switch. The vehicle will sound three beeps in order to
verify the Program Mode
has been activated.
9. Press the LOCK and
UNLOCK buttons together on the keyless entry
transmitter and hold until the vehicle beeps
twice to verify that the
transmitter has been successfully programmed (this take approximately
15
seconds).
10. Perform the previous step to
program up to four transmitters (including your
old ones).
11. Remove the ignition key in order to exit the Program Mode.