1.      Make sure ignition is in the OFF position.    

2.      Locate the Programming Connector in the trunk (driver’s side). It is a plastic connector with two
      wires leading up to it. The connector is not plugged into anything. You may have to pull back trim
      to access the connector.    

3.      The programming connector should have two terminals. Connect both terminals with a suitable
       jumper wire. Make sure the terminals remain connected throughout the programming procedure.

4.      Press the LOCK and UNLOCK buttons on the transmitter simultaneously. In response, the
      Keyless Entry Module will cycle all the Door Lock Motors at once. Your new remote has been
      accepted and all existing remote codes have been erased.    

5.      Repeat the previous step for each additional transmitter (including any existing transmitters). Do
      not remove jumper wire in between programming of transmitters.    

6.   Remove the jumper wire from the Keyless Programming Connector.