1. Locate the Data Link Port. It is located under dash drivers side. Be sure you know which pins are 8 and 4.
(Notice port is wider on top row)
2 Make sure there are metal contact pins in terminals 8 and 4. Connect 8 to 4 with a suitable jumper wire (leave the jumper wire connected throughout
the programming procedure). Make sure
you know which terminals are 8 and 4. The vehicle will respond by locking and unlocking the doors to signify entering of programming mode.
3. Press and hold both the LOCK and UNLOCK
buttons together on the first transmitter to be programmed. After about
15 seconds, the vehicle will respond by locking and unlocking the
doors. Release the buttons on the transmitter.
4. Within one minute, repeat
the previous step on the remaining transmitters to be programmed.
5. Remove jumper wire from
the OBDII port.